Preparing our 1/4 scale mock-up – Seal, Edeline, Justin

I’m a little behind on the blog posting!

Seal recently posted about finishing the form finding for our structure and flattening the pieces to be lasercut. We were also able to label each of the hex surfaces on the structure with its index using the Text Tag 3D component so we could identify each piece:

labeled surfaces on structure

One problem that became apparent is that the normals for each of these surfaces do not face the same direction – some face inside and some outside (as you can see in the photo, some of the text is backwards). We need to establish a clear direction for the final so that the lasercut score line folds in the right direction.

Also, putting together the pieces based on this index alone was difficult because the orientation of each piece was not clear. For the final, we are thinking of labeling each edge or vertex so we know quickly how the pieces fit together.

We were also able to generate “tabs” for each hexagon. We baked the flattened hex surfaces into Rhino and ran a separate GH file to generate the tabs. We identified the edges of each hex surface, offset each edge, and then drew a line from the start/end point of the original edge to the offset line. We were able to use the Color component in the Vector area to make the hex edges black (RGB 0,0,0) and the tab outline red (RGB 255,0,0) so they would be ready to lasercut.

labeled surfaces flat

Leave a Reply

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s