Jehs-Laub Lounge: Grasshopper Final Version

I’ve been struggling with the screen recordings, so here’s a low-tech version of my parameters in action:

I created the curves for the chair by referencing points from Rhino. I selected the top 3 points and connected a slider to them to change the x and z coordinates.

The bounding boxes that are referencing the geometry (“cushions”) onto the surface can change height by a number slider.

Those same bounding boxes can also be controlled by an attractor point, moving on the surface.

“Cushions” can change size in length….

…and in width. The original chair is a 3×5 grid.

This is the original Jehs-Laub Lounge chair made in Grasshopper:

These are my 5 design proposals, including the Grasshopper parameters I used for each one:

Aldana Ferrer Garcia.-